MAX3097ECSE+T

General Description 

The MAX3097E/MAX3098E feature three high-speed RS485/RS-422 receivers with fault-detection circuitry and fault-status outputs. The receivers’ inputs have fault thresholds that detect when the part is not in a valid state. The MAX3097E/MAX3098E indicate when a receiver input is in an open-circuit condition, short-circuit condition, or outside the common-mode range. They also generate a fault indication when the differential input voltage goes below a preset threshold. See Ordering Information or the Electrical Characteristics for threshold values. The fault circuitry includes a capacitor-programmable delay to ensure that there are no erroneous fault conditions even at slow edge rates. Each receiver is capable of accepting data at rates up to 32Mbps.

Features 

♦ Detects the Following RS-485 Faults: Open-Circuit Condition Short-Circuit Condition Low Differential Voltage Signal Common-      Mode Range Violation 

♦ ESD Protection ±15kV—Human Body Model ±15kV—IEC 1000-4-2, Air-Gap Discharge Method ±8kV—IEC 1000-4-2, Contact        Discharge Method 

♦ Single +3V to +5.5V Operation 

♦ -10V to +13.2V Extended Common-Mode Range 

♦ Capacitor-Programmable Delay of Fault Indication Allows Error-Free Operation at Slow Data Rates 

♦ Independent and Universal Fault Outputs 

♦ 32Mbps Data Rate 

♦ 16-Pin QSOP is 40% Smaller than IndustryStandard 26LS31/32 Solutions

Feature

Applications

(Picture: Pinout)