MAX3222ECDW

FEATURES
· ESD Protection for RS-232 Bus Pins
-±15-kV Human-Body Model(HBM)
-±8-kV IEC61000-4-2, Contact Discharge
-±15-kV IEC61000-4-2, Air-Gap Discharge
· Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU v.28 Standards
· Operates With 3-V to 5.5-V Vcc Supply
· Operates up to 500 kbit/s
· Two Drivers and Two Receivers
· Low Standby Current...1 uA Typ· External Capacitors...4×0.1 uF
· Accepts 5-V Logic Input With 3.3-V Supply
· Alternative High-Speed Pin-Compatible Device

(1 Mbit/s) for SNx5C3222E 

APPLICATIONS
· Battery-Powered Systems
· PDAS
· Notebooks
· Laptops
· Palmtop PCs

· Hand-Held Equipment

DESCRIPTION/ORDERING
  INFORMATION The MAX3222ECDW consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin(serial-port connection pins, including GND).

  The MAX3222ECDW can be placed in the power-down mode by setting the power-down PWRDOWN) input low, which draws only 1 uA from the power supply. When the device is powered down, the receivers remain active while the drivers are placed in the high-impedance state. Also, during power down, the onboard charge pump is disabled;V+ is lowered to Vec, and V-is raised toward GND. Receiver outputs also can be placed in the high-impedance state by setting enable(EN) high.

 The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector.The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply.The device operates at typical data signaling rates up to 500 kbit/s and a maximum of 30-V/us driver output slew rate.

Feature

(Picture:Pinout / Diagram)