The TC520ACOE Serial Interface Adapter provides logic control for Microchip's TC500/500A/510/514 family of dual slope,integratingA/Dconverters. ItdirectlymanagesTC500 converter phase control signals A, B, and CMPTR thereby reducing host processor task loading and software complexity. Communication with the TC520ACOE is accomplished over a 3wire serial port. Key converter operating parameters are programmable for complete user flexibility.Data conversion initiated when the CE input is brought low. The converted data (plus overrange and polarity bits) are held in an 18 bit shift register until read by the processor, or until the next conversion is completed. Data may be clocked out of the TC520ACOE at any time, and at any rate the user prefers. A Data Valid (DV) output is driven active at the start of each conversion cycle indicating the 18 bit shift register update has just been completed. This signal may be polled by the processor, or can be used as data ready interrupt.The TC520ACOE timebase can be derived from an external frequency source of up to 6MHz; or can operate from its own external crystal. It requires a single 5V logic supply and dissipates less than 7.5mW.
Feature
- Converts TC500/500A/510/514 to Serial Operation
- Programmable Conversion Rate and Resolution for Maximum Flexibility
- Supports up to 17 Bits of Accuracy Plus Polarity Bit
- Low Power Operation: Typically 7.5mW
- Polled or Interrupt Mode Operation
- 14-Pin PDIP or 16-Pin SOIC Packages
