The SST26WF064C-104I/SM Serial Quad I/O (SQI) flash device utilizes a 4-bit multiplexed I/O serial interface to boost performance while maintaining the compact form factor of standard serial flash devices. SST26WF064C-104I/SM also supports full command-set compatibility to traditional Serial Peripheral Interface (SPI) protocol. Operating at frequencies reaching 104 MHz, the SST26WF064C-104I/SM enables minimum latency execute-in-place (XIP) capability without the need for code shadowing on an SRAM. The SST26WF064C-104I/SM writes (Program or Erase) with a single power supply of 1.65-1.95V and significantly lower power consumption. The device’s low power consumption makes it the ideal choice for wireless and any battery powered devices. Further benefits are achieved with SST’s proprietary, high-performance CMOS SuperFlash® technology, which significantly improves performance and reliability.
Feature
- Single Voltage Read and Write Operations - 1.65 V - 1.95V
- Serial Interface Architecture
- x1/x2/x4 Serial Peripheral Interface (SPI) Protocol
- Nibble-wide multiplexed I/O’s with SPI-like serial command structure
- Dual-Transfer Rate (DTR) Operation
- High Speed Clock Frequency
- 104 MHz max
- 54 MHz max (DTR)
- Burst Modes
- Continuous linear burst
- 8/16/32/64 Byte linear burst with wrap-around
- Superior Reliability
- Endurance: 100,000 Cycles (min)
- Greater than 100 years Data Retention
- Low Power Consumption:
- Active Read current: 15mA (typical@104MHz)
- Standby current: 10μA(typical)
- Deep Power-Down current: 2.5μA(typical)
- Fast Erase Time
- Sector/Block Erase: 18 ms (typ), 25 ms (max)
- Chip Erase: 35 ms (typ), 50 ms (max)
- Page-Program
- 256 Bytes per page in x1or x4mode
- Flexible Erase Capability
- Uniform 4Kbyte sectors
- Four 8Kbyte top and bottom parameter overlay blocks
- One 32Kbyte top and bottom overlay block
- Uniform 64Kbyte overlay blocks
- Write-Suspend
- Suspend Program or Erase operation to access another block/sector
- Software and Hardware Reset mode
- Supports JEDEC-compliant Serial Flash Discoverable Parameter (SFDP) table
- Software Protection
- Individual-Block Write Protection with permanent lock-down capability
- Read Protection on top and bottom 8Kbyte parameter blocks
- Security ID
- One-Time Programmable (OTP) 2KByte, Secure ID
- 64 bit unique, factory pre-programmed identifier
- User-programmable area
- Temperature Range
- Industrial: -40°C to +85°C
- Packages Available
- 8-contact WDFN (6mm x 5mm)
- 8-lead SOIJ (5.28 mm)
- 16-lead SOIC( 7.50mm)
- 24-ball TBGA (8mmx6mm)
- All devices are RoHS compliant
