EPCOS PM87/70 coil formers are made from GFR polyterephthalate UL 94 V -0 to class 60085. Maximum operating temperature +155°C.Solderability to IEC 60068-2-20
Feature
High-performance CMOS EEPROM-based programmable logic devices (PLDs) built on third-generation Multiple Array MatriX (MAX®) architecture
■ 5.0-V in-system programmability (ISP) through built-in IEEE Std. 1149.1 Joint Test Action Group (JTAG) interface
■ Built-in JTAG boundary-scan test (BST) circuitry compliant with IEEE Std. 1149.1-1990
■ High-density erasable programmable logic device (EPLD) family ranging from 6,000 to 12,000 usable gates (see Table 1)
■ 10-ns pin-to-pin logic delays with counter frequencies of up to 144 MHz
■ Fully compliant with the peripheral component interconnect Special Interest Group’s (PCI SIG) PCI Local Bus Specification, Revision 2.2
■ Dual-output macrocell for independent use of combinatorial and registered logic
■ FastTrack® Interconnect for fast, predictable interconnect delays
■ Input/output registers with clear and clock enable on all I/O pins
■ Programmable output slew-rate control to reduce switching noise
■ MultiVolt™ I/O interface operation, allowing devices to interface with 3.3-V and 5.0-V devices
■ Configurable expander product-term distribution allowing up to 32 product terms per macrocell
■ Programmable power-saving mode for more than 50% power reduction in each macrocell
