The TDF8546AJS/N1ZS is one of a new generation of complementary quad Bridge-Tied Load (BTL)audio power amplifiers intended for automotive applications. It has a best efficiency modewith full I2C-bus controlled diagnostics, including start-up diagnostics. The TDF8546AJS/N1ZS canoperate at a battery voltage as low as 6 V making this amplifier suitable for stop/start-caroperation.
The new best efficiency principle uses a patented switch technique which reducesswitching distortion. To reduce power dissipation, the new best efficiency principle usesthe audio information on all four channels instead of only the front or rear signals.Dissipation is more than 65 % less than standard BTL when used for front and rearcorrelated audio signals. Dissipation is 35 % less than standard BTL when used foruncorrelated (delayed) audio signals between front and rear, and 17 % less foruncorrelated audio signals when the front or rear information is used.
The amplifier uses a complementary DMOS output stage in a Silicon-On-Insulator (SOI)-based BCD process. The DMOS output stage ensures a high power output signal withperfect sound quality. The SOI-based BCD process ensures a robust amplifier, wherelatch-up cannot occur, with good separation between the four independent channels, withevery component isolated and without substrate currents.
Feature
- Stop/start-car prepared: keeps operating without audible disturbance during enginestart at a battery voltage as low as 6 V
- New best efficiency mode with patented low switching distortion
- Extreme best efficiency mode (uses information from 4 channels) with 17 % lessdissipation for uncorrelated signals compared to 2-channel best efficiency mode
- Operates in either legacy (non I2C-bus) or I²C-bus modes (3.3 V and 5 V compliant)
- Four hardware-programmable I2C-bus addresses
- Can drive 2 Ω and 4 Ω loads
- Speaker fault detection
- Start-up diagnostics with load detection: open, short, present; filtered for door-slamand chatter relays
- AC load (tweeter) detection with low and high current mode
- Gain select after start-up without audible disturbance
- Independent selectable soft mute of front and rear channels
- Programmable gain (26 dB and 16 dB), independently programmable for the front andrear channels
- Line driver mode supports engine start at a battery voltage as low as 6 V (16 dB andmid-tap voltage 0.25 VP)
- Programmable clip detect: 2 %, 5 % or 10 %
- Programmable thermal pre-warning
- Pin STB can be programmed/multiplexed with second-clip detect
- Clip information of each channel can be directed separately to pin DIAG or pin STB
- Independent enabling of thermal-, clip- or load fault information (short across the loador to VP or to ground) on pin DIAG
- Loss-of-ground and open VP safe (minimum series resistance required)
- All amplifier outputs short-circuit proof to ground, supply voltage and across the load(channel independent)
- All pins short-circuit proof to ground
- Temperature controlled gain reduction to prevent audio holes at high junctiontemperatures
- Programmable low battery voltage detection to enable 7.5 V or 6 V minimum batteryvoltage operation
- Over-voltage protection (load-dump safe up to VP = 50 V) with over-voltage pre-warningat 16 V
- Offset detection
